If not working, unplug the router for 30sec and retry.Let the client router reboot and connect to the host, then configure on the new Client IP address as needed.Click Apply, then change the computer back to auto IP/DNS if needed (replug the LAN cable if not working).(Optional) In Security->Firewall, disable SPI Firewall if security between AP & Client is not needed.(Optional) Set a "Server IP/Name" in Time Setting section for NTP (blank uses a default server).(Recommended) Change the Time Zone and DST settings as needed.(Optional) Set Static DNS servers in Network Address Server Settings (DHCP) if not provided or wanted from WAN.(Optional) Set your local DNS to the IP address of your client router.The device should be in GATEWAY Advanced Routing mode, not ROUTER, or Masquerade/NAT does not happen.Set the Gateway address to the primary host router gateway or internet will not work (e.g.In Network Setup set the Local IP Address to a different subnet from the primary host router (e.g.This is the setting that is bonded to the wireless interface. If the client router requires external management, go to Setup->Basic Setup, set the WAN port protocol as needed and enter info provided by your ISP.Static IP allows easier access remote GUI, SSH, or telnet access is enabled under Administration.Go to Setup->Basic Setup: if needed, change Connection Type to Static IP from "Automatic Configuration - DHCP".(Optional) If available, in Wireless tab (or under Advanced), set (or disable) the Ack Timing in meters.Wireless Security: set the Security Mode and other information same as primary router.
DD WRT V24 SP2 GB WIFI MAC
MAC Address can be found on the "Site Survey" page, linked from the Wireless tab in Status.the primary router, instead of a repeater), enable MAC Filtering on the Wireless Tab, and add the specific device's MAC Address. If multiple routers broadcast the same SSID, to connect to a specific one (i.e.Set the Wireless Network Name (SSID) to exactly match the primary router.In Wireless->Basic Settings and change the Wireless Mode to "Client".Go to Wireless: these settings must match the primary host router - Check spelling and case!.